Marpac Stereo Pillow Speaker Set

Listening to music or television without disturbing others or using a Marpac sound conditioner for noise masking or o add sound where it might otherwise be too quiet, the PS-2 is an excellent choice for superior sound quality. With proper care and use you should receive much satisfaction from this product.

Important Safeguards:

• Read all instructions.
  
• Do not sleep with excess slack in the Stereo
• Pillow Speakers cord. Gather the loose cord and use a twist tie, rubber band, or other fastener to secure excess cord in a tight bundle.
• When possible, route the cord of the speakers toward the headboard of your bed. This placement will help keep the cord out of theway if you toss and turn during sleep.
• Do not use with infants. Take special care to keep the cord away from infants.
• Do not use in or around water.
• Do not operate with a damaged cord or if the speakers malfunctions or has been damaged inany manner.
• The speakers should be situated away from heat sources such as direct sunlight, radiators, heat registers, stoves or other heat-producing appliances.

Use Pillow Speakers:

Your Stereo Pillow Speaker Set can be used with any type or size of pillow. Please follow these steps to play music or sounds through your Stereo Pillow Speaker Set.

1. Connect the SPEAKER PLUG to the sound  output jack on your sound source.

Note: If you are using a Marpac Sound Conditioner, insert the SPEAKER PLUG into the
ACCESSORY JACK on your Marpac Sound Conditioner.

2. Place the Stereo Pillow Speaker Set under your selected pillow. To experience optimum
volume, position the speakers with the speaker grills facing up. To experience the best sound
quality, position the speakers at opposite ends of your pillow.

3. Adjust the volume and/or balance controls on your sound source to your desired level.
Note: If you cannot hear sound coming from your Stereo Pillow Speaker Set, check to ensure
that the SPEAKER PLUG is firmly inserted into the sound output jack on your sound source.

Technical Specifications

Speaker Jack: 1/8” (3.5 mm) plug

Speaker Output: 4 ohm, 2-watt speakers

Product Reviews

Write an online review and share your thoughts.